My Command Line is Missing!!

by

Some of you might have noticed that with the 2013 products, by default, the command line is floating.

I was teaching class this week and plugged my laptop into a projector that had a screen resolution lower than my initial setting.  When I booted up my Autodesk product, the command line was below the screen.  I couldn’t grab it to drag it back to a spot where I could see it.  I changed my screen resolution back to it’s original setting, and to no avail, the command line stayed where it was, out of the viewing area.

SOLUTION

To get the command line back, type in CUI at the command line.  In the pane on the left side, click on your current workspace.  This will populate the pane on the right.  Expand Palettes, and click on Command Line.  This will populate the Properties pane just below.

Change the Orientation from Floating to your desired docked position (Above, Below, etc.).

4-4-2012 8-46-10 AM

Click OK and your command line will be back.  You can then make it floating again by dragging it away from it’s docked position.

Advertisements

Tags: , , , , , ,

2 Responses to “My Command Line is Missing!!”

  1. Todd Rogers Says:

    Everyone can see images on my end.

  2. Nike Free Says:

    That is a very good tip especially to those new to
    the blogosphere. Short but very precise information… Thanks for sharing this one.
    A must read post!

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s


%d bloggers like this: